Separate evidence from inference.
Identified the source-data gaps, edge noise, and continuity defects, while preserving the fit-critical interfaces that governed the reconstruction.
Project record 03 / Advanced CAD + reconstruction
Imperfect scan and mesh evidence became continuous, editable geometry with recovered datums and fit-critical interface logic.
Surface reconstruction, design-intent recovery, editable SolidWorks definition, and neutral-data delivery.
Editable CAD delivered
Independent consulting
Anonymized public record
The governing question
Supplied scan and mesh data had holes, edge noise, and continuity defects that prevented controlled editing.
Editorial schematic of the engineering scope. Not product geometry.
Engineering decisions
Closing holes alone doesn’t establish the intended shape or recover its critical relationships. I separated measured evidence from inference, then used surface construction and editable features to restore a model that could support further engineering.
Identified the source-data gaps, edge noise, and continuity defects, while preserving the fit-critical interfaces that governed the reconstruction.
Used loft, sweep, and filled surfaces to bridge gaps and recover controlled geometry, rather than simply converting the original mesh.
Recovered datum relationships and feature logic, then delivered native SOLIDWORKS geometry and neutral STEP data.
What the work produced
Editable CAD and a client-approved replica were delivered. This record does not establish production qualification.
A similar challenge?
Bring the current design, the governing constraints, and the decision the team needs to make.
Discuss your project